ARID USA Enhanced Charging Handle for the Steyr AUG A3M1/A3SA

Designed and refined in house, Produced in the USA, the ARID enhanced charging handle makes some much desired improvements over the standard unit. ONLY COMPATIBLE WITH A3M1/A3SA VARIANTS

- Aluminum construction
- Revised angle for easier overhand charging (for you heathens who can't RTFM)
- 3 lengths offered to suit end user
  - Short : 7/8" length
  - Medium : 1 1/8" length
  - Long : 1 3/8" length
- 3 colorways
  - Black
  - ODG
  - FDE
- Lower profile and smoothed edges (to help avoid sling snag)
- Removes forward assist
- It's pretty

*Installation notes*

1. Use some form of thread locker on the retaining bolt, we suggest VC3 thread locker or purple low strength loctite.

2. The bolt just needs to be snug, DO NOT OVERTIGHTEN!  Seriously, 5-8 INCH/lb NO MORE. You don't need to tighten this thing down within an inch of its life. We will NOT warranty a charging handle because you decided you were going to impersonate the hulk when assembling. Snug with the thread locker mentioned in installation note 1, will more than do the trick.

3. This charging handle to shuttle interface is a slight friction fit, we suggest tapping the handle onto the shuttle using a rubber mallet to get it properly seated so the retaining bolt can be installed.

WILL NOT FIT A3M2